样品申请 | 联系我们
所有搜索
Car Diagnostic Tools
Bluetooth keyboard
Autocom CDP+
Creader VII
样品申请
联系销售
反馈
STM32F105RBT6

The STM32F105RBT6 microcontroller has 128KB of Flash, 32KB RAM, 7 timers, 3 SPI, 2 I2S, 2 I2C, 5 USART, USB OTG FS, 2 CAN, 51 I/Os in a 64-Pin 10mm x 10mm x 1.4mm LQFP package.
The STM32F105xx and STM32F107xx connectivity line family incorporates the high performance ARM® Cortex™-M3 32-bit RISC core operating at a 72 MHz frequency, highspeed embedded memories (Flash memory up to 256 Kbytes and SRAM up to 64 Kbytes), and an extensive range of enhanced I/Os and peripherals connected to two APB buses. All devices offer two 12-bit ADCs, four general-purpose 16-bit timers plus a PWM timer, as well as standard and advanced communication interfaces: up to two I2Cs, three SPIs, two I2Ss, five USARTs, an USB OTG FS and two CANs. Ethernet is available on the STM32F107xx only.

The STM32F105xx and STM32F107xx connectivity line family offers devices in three different package types: from 64 pins to 100 pins. Depending on the device chosen, different sets of peripherals are included, the description below gives an overview of the complete range of peripherals proposed in this family.

Features:

Core: ARM 32-bit Cortex™-M3 CPU
72 MHz maximum frequency, 1.25 DMIPS/MHz (Dhrystone 2.1) performance at 0 wait state memory access
Single-cycle multiplication and hardware division
Memories
64 to 256 Kbytes of Flash memory
up to 64 Kbytes of SRAM
Clock, reset and supply management
2.0 to 3.6 V application supply and I/Os
POR, PDR, and programmable voltage detector (PVD)
3-to-25 MHz crystal oscillator
Internal 8 MHz factory-trimmed RC
Internal 40 kHz RC with calibration
32 kHz oscillator for RTC with calibration
Low power
Sleep, Stop and Standby modes
VBAT supply for RTC and backup registers
2 x 12-bit, 1 μs A/D converters (16 channels)
Conversion range: 0 to 3.6 V
Sample and hold capability
Temperature sensor
up to 2 MSps in interleaved mode
2 x 12-bit D/A converters
DMA: 12-channel DMA controller
Supported peripherals: timers, ADCs, DAC, I2Ss, SPIs, I2Cs and USARTs
Debug mode
Serial wire debug (SWD) & JTAG interfaces
Cortex-M3 Embedded Trace Macrocell™
Up to 80 fast I/O ports
51/80 I/Os, all mappable on 16 external interrupt vectors and almost all 5 V-tolerant
Up to 10 timers
Up to four 16-bit timers, each with up to 4 IC/OC/PWM or pulse counter and quadrature (incremental) encoder input
1 x 16-bit motor control PWM timer with dead-time generation and emergency stop
2 x watchdog timers (Independent and Window)
SysTick timer: a 24-bit downcounter
2 x 16-bit basic timers to drive the DAC
Up to 14 communication interfaces
Up to 2 x I2C interfaces (SMBus/PMBus)
Up to 5 USARTs (ISO 7816 interface, LIN, IrDA capability, modem control)
Up to 3 SPIs (18 Mbit/s), 2 with a multiplexed I2S interface that offers audio class accuracy via advanced PLL
chemes
2 x CAN interfaces (2.0B Active) with 512 bytes of dedicated SRAM
USB 2.0 full-speed device/host/OTG controller with on-chip PHY that supports HNP/SRP/ID with 1.25 Kbytes of dedicated SRAM
10/100 Ethernet MAC with dedicated DMA and SRAM (4 Kbytes): IEEE1588 hardware support, MII/RMII
vailable on all packages
CRC calculation unit, 96-bit unique ID
Applications:

PLCs
Printers
Scanners
Alarm systems
Video intercoms
HVAC

上一篇:STM32F105RBT6
下一篇:
返回顶部
  关于腾迈 | 产品中心 | 人力资源 | 联系我们
Copyright © 2010-2011 腾迈科技 All Rights Reserved.
粤ICP备1205279(1/3)号